How Do I Keep Glued Boards From Slipping?
// November 5th, 2009 // No Comments » // Jalan-jalan
The trick is to apply just the right amount of glue and pressure. First, use a
squeeze bottle to make a long zigzag or spiral pattern of glue over the bottom piece. Then place the other piece of wood on top and rub the two together, pressing fairly hard. This spreads out the glue to cover the whole surface. Rubbing also squeezes out the excess glue so what remains absorbs into the wood and gets tacky faster. After a minute or so, the glue will begin to grip. Now slide the boards into alignment.
Put on your clamps, but only apply enough pressure to keep the clamps upright. Then tighten each clamp a little bit at a time, like putting lug nuts on a wheel. The glue tack and the gradual tightening will keep the pieces just where you want them.











